Home About WEC News Products Applications Industries Served Technical Literature
 

Technical Support

Click on a link below for more information:

Model Number Description

Equations

Reference Data



Ohm's Law

To Determine: For Single Phase - Calculate: For Three Phase - Calculate:
AMPS =
WATTS =
VOLTS =
Ohm's Law
Back to Top

 

Amperage

  Many local electrical codes and good engineering practices limit line current to 48 amps. When this total heater total heater limit is exceeded, Warren Electric heaters are designed with multiple circuits which limit the line current below 48 amps per circuit. Please consult factory to discuss other options. Determining Line Current = "I" (amperes)  
Single Phase:   Three Phase:  
Back to Top

 

Determining Required Power

  Power (KW) =   FR = Flow rate in Gallons Per Hour (static reservoirs use gallon capacity) In a Circulating System this is the Actual Flow Rate During Operation
gc = Specific Gravity of Fluid/Gas
CP = Specific Heat of Fluid/Gas (BTU/(lb. °F))
DT = Differential Between Outlet Temperature and Inlet Temperature (°F)
SF = Safety Factor (typically 20%) SF = 1.2
8.34 = Weight of water per gallon (lb./Gal)  
Back to Top

 

Wattage Differential

When heaters are operated at voltages other than the design voltage, different power outputs will result. It is acceptable to use Warren Electric heaters up to 10% above the design voltage and any percentage below. (Note: Applied voltage will affect the power output as shown below.)   Determining Actual Power Output:  Warren Electric heaters are normally range rated (showing the recommended maximum and minimum applied voltage and corresponding wattage). The table below shows the standard Warren Electric ranges as they apply.
Design Voltage Nameplate Voltage Nameplate Wattage
120
240
480
550
110-120
220-240
440-480
550-575
Corresponds to the output wattage at nameplate voltage
Back to Top